How To Use Grommet Pliers

Steps

1

Cut a hole in your fabric where yous want the eyelet to go. This hole needs to be only big enough to push your eyelet through. If it is too big the eyelet will fall out.^[1]
2

Use a pad under the textile to make a clean cutting. The pad may be: a piece of difficult leather ( run into next photo ), an acrylic cake like the cutting boards used in kitchens, a plastic floor tile or even a canvass of newspaper folded many times. Make sure you lot go on everything in identify while making the hole !

Advertisement
3

To cut the hole ever put the pad under the "bad side" of the cloth. Exert potent pressure with the pliers or use a hammer to bulldoze a hole with the eyelet dial.
4

Push button the eyelet through the hole yous have made. Do this from the right side of your fabric so the apartment office of the eyelet is on the proficient side.
v

Constrict any loose threads under the flat part of the eyelet so they are not visible.
six

Align your eyelet pliers. ^[2] The flat (good) side of your eyelet should sit in the slightly curved side of the pliers, while the tube (bad) side of the eyelet should be aligned with the "pointed" side of the pliers.^[three]
vii

Squeeze the pliers together. ^[4]
8

Have the pliers away and check that the eyelet is prepare equally you want it. If it can be rotated in the material you volition need to repeat the previous stride with a piffling more force until it holds the material tightly.

Advertisement

Add New Question

Question

Can I use the eyelet pliers for grommets?

No, grommets take a larger diameter than eyelets. Y'all would need the correct size die to represent with the size of the grommets that y'all are using. If you are using multiple sizes of grommets, you would need multiple sets of dies.
Question

Is it possible to make an eyelet hole in a canopy made from polyester material?

Yes, but you would desire to reinforce the polyester before making the pigsty so that the cut threads exercise not unravel. Since the projection is a canopy, the "eyelet" would actually exist a grommet. Essentially, a grommet is the larger cousin to the eyelet. They have similar appearances, but their functions are unlike. An eyelet is smaller, comes in a diversity of decorative colors, and has little force. Eyelets are used for ribbons, low-cal cords, laces, or decoration. Grommets are used for structural reinforcement to protect the fabric from tearing when exposed to stress. Grommets are used on tarps, shower curtains, canvas bags, canopies, tents, boat covers, etc.
Question

What can I utilize if I don't have an eyelet pliers?

You can use needle olfactory organ pliers to peel the edges downward and and so use a hammer on a hard surface to flatten it.